Check if both computer and AP-60 are at the same segment.
Close all firewalls available to prevent blocking of package sending.
Try default IP(PING 192.168.10.89) to check if any responses when the above steps are unable to help to find AP-60. If there is a response, enter the default IP to open the setting page using the browser(IE).
Check both the wirings between AP-60 and the computer. No gateway is given for the initial setting of AP-60 and user must do the setting at the same segment.
(a)Either real or virtual IP that is assigned to AP-60 works well and it has to be a fixed IP. A virtual IP
(192.168.xxx.xxx) is normally assigned to AP-60 and user needs to set the IP as a fixed IP in order to detect AP-60 easily. AP-60 also supports DHCP and user needs to set the IP as a fixed or reserved IP.
Incomplete input of system password, please check if correct format “*# XXXX #” (XXXX as system password) has been entered as required in manual.
System password has been changed. Inquire reader’s parameter to get the password if it is networking reader. Contact your nearby agent or return to the manufacturer if it is stand-alone reader.
Bad wire arrangement which might cause short circuit of the PC board. Check the power supply and the control wires in order to avoid the wires pressing on the PC board causing bad contact, short circuit and interference.
Strong interference from other equipments or same type unit caused the new unit is unable to enter Setting Mode or slow response from the keypad. Move the new unit to other place to test again